This project will reseal the barrel vault roof and replace roof sections A, B, C, D, G, J and I at the College of Design. This project includes, but is not limited to, replacement of the roof with a system designed for a minimum life expectancy of 30 years; roof insulation to meet current energy codes; roof access and safety improvements as needed to meet current university standards; tuckpointing, caulking of all features, roof curbs and parapet walls above the roofline to prevent water infiltration; removal and replacement of all sealant on the barrel vault roof. Abatement will be completed as necessary.

This project includes, but is not limited to, asphalt milling, asphalt patching, grading, installation of storm sewer, subgrade preparation, PCC paving, HMA paving, sidewalk replacement, erosion control, pavement markings and surface restoration.

This project includes, but is not limited to, demolition and rebuild of up to 200 feet of existing steam tunnel, replacement of existing steam and condensate pipes, anchors, expansion joints, addition of new steam tunnel access with new reinforced concrete for better structural integrity, and installation of multiple sets of new underground high voltage conduits and two electrical utility vaults west of Beardshear Hall. The physical size of the tunnel will increase for the safety and reliability of the steam distribution system. A new exterior tunnel side chamber access will be added in a section of tunnel that is only accessible from inside Beardshear. Additionally, the project will install new conduits and vaults, allowing for the installation and routing of new high-voltage cable around the west and north sides of Beardshear Hall. The conduits will be upsized to allow for new increased cable capacity and for the raceways to be readily accessible, and cables more easily maintainable and replaceable. This will also remove the safety hazard of a 4160V cable inside the building, once the cable is installed in the new conduits routed around the building.

The scope of work includes, but is not limited to, installing approximately 300 feet of a new bored-in steam condensate line between existing steam vaults, installing approximately 80 feet of direct-bury steam condensate pipe, performing condensate pipe welding, building and vault core drills and patching, removing and replacing sidewalks, and excavation and backfill.

The scope of work includes, but is not limited to, removing existing EPDM roofing and insulation, removing two ventilators, and infilling open areas with roof panels. Install new insulation and EPDM roofing, as well as new flashing at vents and piping. Rework and install a new flashing tie-in to the existing west metal roof.